---
url: https://qsteelcad.com/en/turkey-light-steel-regulation-2027/checklist
language: en
alternate: https://qsteelcad.com/hafif-celik-yonetmeligi/kontrol-listesi
updated: 2026-11-06
publisher: RENMAE Teknoloji ve Yazılım LTD. ŞTİ.
---

# Light steel fabrication and erection checklist

A simplified version of Table 10.1. Tick the items, print them or save as PDF.

## Material check

- Steel grade: Does the steel conform to TS EN 10346 and TS EN ISO 1461?
- Quality certificate: Was the mill test certificate of the steel sheet checked?
- Galvanized coating: Was the coating amount selected according to Annex 1 Table 1?
- Screws and fasteners: Were the requirements of Section 2 met for the screws?
- Holes made on site: Were holes and cuts repaired with zinc-rich paint?

## Cross-section requirements

- Profile dimensions: Do the flange, web and stiffener dimensions meet the limits?
- Bend radii: Do the inner bend radii meet the limits?
- Flange width: Does the flange width meet the minimum limits?

## Conformity to the project

- Profile production: Was the accuracy of the profiles checked against the project?
- Section check: Were shape, dimensions and surface flatness compared with the project?
- Screw check: Do the diameter, position and frequency of the screw holes conform to the project?

## Erection

- Layout: Are the position and alignment of the members correct?
- Connections: Were the specified number and type of screws used?
- Anchor installation: Were the anchors installed at the specified diameter and spacing?
- Connection gussets: Were the gussets fixed with the specified number and size of screws?

## Panel systems

- Sheathing panel layout: Is the stud spacing at most 625 mm and the studs ≥ 0.9 mm?
- Panel frame: Are the top and bottom tracks from profiles ≥ 0.8 mm?
- Screw connections: Were the sheathing panels screwed on all four edges according to the project and TBDY?
- Horizontal bridging: Was the bridging placed at no more than half the panel height?

## Floor system

- Floor joists: Are the joists in the section and spacing required by the project?
- Web reinforcement: Were the stiffeners and connection elements installed in sufficient numbers?
- Floor connections: Were the web and joints connected with screws as required by the project?

## Fire and report

- Fire design: Were the requirements of Section 11 met?
- Design report: Was the calculation report attached?


> This page is an independent guide prepared by RENMAE. It is not the official text and does not replace legal or engineering advice. The binding text is the one published in the Official Gazette.